Service manual
– 8 –
Relay
1. Remove the cooker control panel as outlined
under Covers and Panels.
2. Remove all the wiring associated with the
relay.
3. Remove the two holding nuts and pull the
relay off of the panel.
4. Reverse the procedure to install new relay.
Thermostat
1. Drain all the water from the cooker tank.
2. Remove the cooker control panel as outlined
under Covers and Panels.
3. Remove knob.
4. Remove the two screws securing the
thermostat to the panel.
5. Remove all the wiring associated with the
thermostat.
6. Follow the thermostat capillary to the packing
nut located on the bottom of the cooker tank.
7. Access to the packing nut can be gained
through the rinse station door on the right
side of the pasta cooker. Remove the packing
nut then remove the thermostat mounting
nut.
NOTE: If more room is required to reach the packing
nut, the right burner may be removed in front of the
cooker tank (see Gas Burners).