Service manual

– 24 –
OPTIONAL BASKET LIFT ASSEMBLY
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
Adjustment
1. Allow pasta cooker to cool.
2. Remove the cooker basket.
3. Pull the lift arm from the cooker.
4. Turn the adjustment bolt to raise or lower the
basket as needed.
Timer Check
1. Remove the cooker control panel as outlined
under Covers and Panels in Removal and
Replacement of Parts.
2. Check for good wire connection at the
terminals.
3. Connect power and switch to ON.
4. Check for 24 VAC across the input terminals
of L1 and L2.
5. Check for 24 VAC across the load terminals
after pushing the timer button and setting the
timer. The reading should remain constant at
24 VAC until the timer runs out.
Relay Check
1. Remove the lower lift mechanism panel as
outlined under Covers and Panels in Removal
and Replacement of Parts.
2. Connect power and switch to ON.
3. Check for 0 ohms between connections 5 and
3, 6 and 4.
4. Turn the power OFF and disconnect.
5. Check for coil resistance of above 168 ohms.
Also check for continuity of 0 ohms across
connections 1 and 5, 0 and 6.
Micro Switch Check
1. Remove the lower lift mechanism panel as
outlined under Covers and Panels in Removal
and Replacement of Parts.
2. Remove switch wiring.
3. Engage the switch and check for continuity
across the common and normally open
circuits.
Motor Check
1. Remove the lower lift mechanism panel as
outlined under Covers and Panels in Removal
and Replacement of Parts.
2. Connect power and check for voltage to the
motor.
3. Verify the motor voltage agrees with the
voltage on the data plate.
4. Disconnect power and disconnect the motor
wires at the motor terminals.
5. Check for 28 ohms of resistance across the
terminals.