Service manual

– 21 –
RINSE TANK
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING.
WARNING: SHUT OFF WATER BEFORE
SERVICING.
1. Remove basket hanger, basket support rack
and basket.
2. Drain rinse tank.
3. Remove the rinse station control panel as
outlined under Rinse Station Control Panel in
Covers and Panels.
4. Remove the rinse tank overflow hose as
outlined under Rinse Tank Hose in Overflow
Hoses.
5. Remove the four nuts and bolts from the tank
support bracket.
6. Remove the two hex head screws at the top
of the rinse station box.
17. Remove the fill port spray nozzle.
NOTE: When reinstalling, the fill port spray nozzle
should be pointed down and angled slightly to
the right. When operating, the spray pattern
should spray the entire width of the tank.
18. With the assistance of another person, stand
in front of the pasta cooker and grasp the
back and the front of the tank. Carefully tilt
the tank back forward and lift the tank out the
pasta cooker body.
19. Reverse procedure to install. Retain the
controls and hardware for reassembly to the
new tank.