Service manual

19
POWER SUPPLY BOX INTERNAL
COMPONENTS
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
To access the power box internal components, remove
the two screws securing the power supply box cover.
Ignitor Module
1. Disconnect all wiring associated with the
ignitor module.
2. Remove the four screws holding the ignitor
module.
3. Reverse the procedure to install new ignitor
module.
Transformer
1. Disconnect all wiring associated with the
transformer.
2. Remove the two screws holding the
transformer.
3. Reverse the procedure to install new
transformer.