Service manual
– 18 –
3. Remove the nuts and bolts securing the
electrical cord holding straps (two places).
4. Pull the ignition cable from the spark ignitor,
and remove the wire attached to the pilot
ignitor assembly bracket.
5. Loosen the two bolts on the bottom of the
power supply box.
6. Slide the power supply box forward and down
to remove.
7. Reverse the procedure to reinstall power
supply box.
2. Remove the two set screws on the crank arm
and the four screws holding the motor to the
mounting bracket.
3. Remove the crank arm and motor.
4. Reverse procedures to install all components.
POWER SUPPLY BOX
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
1. Remove the upper and lower lift mechanism
panel as outlined under Upper and Lower Lift
Mechanism Panels in Covers and Panels.
2. Disconnect the wiring harness from the power
supply box (two places).