Service manual

– 13 –
6. With an offset screwdriver, remove the two
screws from the ignitor/pilot holding bracket
and pull the assembly from the cooker tank.
7. Reverse the procedure to install new pilot
ignitor assembly.
PILOT IGNITOR ASSEMBLY
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING.
WARNING: ALL GAS JOINTS DISTURBED DURING
SERVICING MUST BE CHECKED FOR LEAKS.
CHECK WITH SOAP AND WATER SOLUTION
(BUBBLES). DO NOT USE AN OPEN FLAME.
1. Remove the cooker control panel as outlined
under Covers and Panels.
2. Remove the control box housing as outlined
under Control Box Housing.
3. Remove the burners as outlined under Gas
Burners.
4. Pull the ignition cable from the spark ignitor.
5. Loosen the pilot tube compression nut.