Service manual

– 10 –
CONTROL BOX HOUSING
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
1. Remove the cooker control panel as outlined
under Covers and Panels.
2. Disconnect the wire harness located on the
bottom right side of the control housing.
3. Remove the four hex head screws holding the
control box housing to the frame.
4. Remove the control box housing.
5. Reverse the procedure to install.
GAS BURNERS
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING.
1. Remove the cooker control panel as outlined
under Covers and Panels.
2. Remove the control box housing as outlined
under Control Box Housing.
3. There are three burners located in front of the
cooker tank. Loosen the bolts above each
burner.
4. Grasp the burner body and push it upward
over the burner nozzle. Tilt the burner head
back and pull out.
5. Reverse the procedure to install.