Specifications

– 7 –

Provide a gas line strain relief to limit movement of the

broiler, without depending on the connector and any quick-

disconnect device or its associated piping to limit the

broiler movement. Attach the strain relief to the rear of the

broiler (Fig. 1).

If disconnection of the strain relief is necessary, turn off the

gas supply before disconnection. Reconnect the strain

relief before turning the gas supply on and returning the

broiler to its original installation position.

UNSTACKING AND STACKING - MODEL GHCB2

Read all instructions carefully before unstacking or stacking broilers.

The height of Models GHCB2 and IR2 sometimes prohibits entry through the kitchen facility doorway.

For this reason, two 3

/4 x 1

/2 x

/64" (95 mm x 38 mm x 1.2 mm), aluminized stacking straps are shipped

with each broiler for ease of top section disassembly.

Broilers Shipped Pre-stacked

1. Remove top section finishing back.

2. From oval slots inside finishing back of the top section, remove two 10-24 bolts which connect

the top and bottom sections (Fig. 2).

3. Remove drip pan and disassemble two 10-24 bolts, one to the left and one to the right of the inside

drip pan area, behind the top section front frame (Fig. 3).

PL-41717

PL-41718

Fig. 2 Fig. 3

4. Carefully remove broiler top section from the bottom section.

5. Leaving the lower far-left and right holes open, reassemble the top finishing back onto the top.

Fig. 1

CONNECT GAS

LINE STRAIN

RELIEF HERE

PL-51216