Griddle User Manual

11 -

CONTROLS – AGM MODELS

The model is equipped with standing pilots. Gas will flow from the pilots as soon as the

main gas supply to the unit is turned on. The pilots are lit with the use of an outside

ignition source (such as a lit taper, etc). There is one pilot for every two burners except

on the 36” and 60” models. The 36” and 60” models have an odd number of main

burners; therefore one of the sets of pilots in these models will control only one main

burner. The pilots are inset 12” from the front panel. See pilot lighting procedure.

Each 12” section of the griddle is independently controlled by an infinite heat control

valve. Once the pilots are lit, turning the burner control knob to the full ON position will

light each burner. The burners will be in the full ON position when the knobs are turned

all the way to the left (Fig. 10). The burners will be in the full OFF position when the

knobs are turned all the way to the right (Fig. 9). The height of the burner flame and

cooking plate temperature can be adjusted by turning the burner control knobs while

viewing burners through the burner sight holes.

burner control

knob

pilot ad

ustment screw

Fig. 9

Fig. 8

Burner control knob in the OFF position.

Turned all the way to the right.

Burner control knob in the full ON

position. Turned all the way to the left -

225 degrees from the OFF position.

Fig. 10

burner and pilot sight

holes