Owner's Manual

9
range of air stream
• device noise level (depending on acoustic characteristics of a room)
• operation mode of the heating device, e.g. it can also operate as an air mixing device preventing air stratification
• direction of air distribution should be controlled in a way that prevents draughts. Air stream must not be directed at walls, brackets, girders, cranes, shelves, machines, etc.
Examples of arrangement of air heating units mounted on a wall
4.1 INSTALLATION WITH A BRACKET
Each unit is supplied with bracket. In order to attach a bracket to the device, use crown drill bits to drill holes in the top and bottom panels of the heating unit (in places marked with
arrows), and insert sleeves (6) into the holes. Slide holder arms onto the sleeves. Insert M10x80mm screws (4) into the top and bottom sleeves, and fix the bracket position in
relation to the heater while tightening the screws. When you adjust the device in the right position, fit plugs onto the bracket.
The bracket unit consists of:
1. ARM (1 piece); 2. HOLDER; 3. M8x60mm SCREW WITH A WASHER AND NUT FASTENING THE CLAMP (2 sets); 4. M8x60mm SCREW FASTENING
THE HOLDER TO THE UNIT HEATER (2 pieces); 5. PLUG (2 pieces); 6. MOUNTING SLEEVE (2 pieces)
* for horizontal air guide adjustment
** for symmetric air guide adjustment at an angle of 45°