Installation Guide

Drainage of condensate

(Version 7.19)

PAGE 1
Drainage of condensate (Version 7.
PAGE 2
Cooling with VOLCANO air heater Prepere a gutter with total length of at least 80 cm for the VR 1, VR 2, VR 3 and at least 63 cm for the VR Mini. The gutter should be plugged at both ends (left and right) and equipped with a drain at any point. Use PVC 120 mm gutter (minimum cross-section A-A of the gutter should be at least 12 cm). Additionally, two gutter hooks should be used to hang the gutter on the heater, the best option is to use a bent hook: rafter hook.
PAGE 3
It is alsow necessary to prepare the pipe for draining the condensate – PVC 32 pipe with a 1-3% drop to ensure drainage of the accumulated condensate. Fig 2. Chart of the condensate drain installation – front The condensate will flow out at the connection point between the front and rear of the housing and through the air outlet zone (under the lowest handlebar). Fig.
PAGE 4
Cooling power tables of VOLCANO devices operating on cold water 7/12°C VOLCANO VR MINI VOLCANO VR 1 Parameters Tz/Tp [°C] Parameters Tz/Tp [°C] Humidity: 50% Humidity: 50% 7/12 Tp1 [°C] 15 20 22 25 30 35 Qp [m3/h] Pg [kW] 2100 1650 7/12 Tp2 [°C] Qw [m³/h] Δp [kPa] 0,7 14 0,12 0,64 0,7 13,8 0,11 0,5 1100 0,6 13,5 0,1 2100 2,1 17 1650 1,8 1100 Tp1 [°C] Qp [m3/h] Pg [kW] Tp2 [°C] Qw [m³/h] Δp [kPa] 5300 0,7 14,6 0,12 0,1 3900 0,7 14,5 0,11 0,1 0,4 2800 0,