Specifications

OPERATING INSTRUCTIONS
sdd2009-001-024_c
TYPICAL
1. CRUISE button
2. Throttle lever
3. UP arrow button
4. DOWN arrow button
Youwillhearabeepindicatingthatyou
are now in cruise mode, and a green
CRUISE indicator light will come on in
the speedometer display of the infor-
mation center.
sdd2009-001-034_a
CRUISE MODE INDICATOR LIGHT
NOTE: Activating cruise mode of op-
eration only limits the maximum speed
available when depressing the throttle
lever. The throttle lever must be held
in to maintain forward speed. Water-
craftspeedcanbevariedfromidleup
to the set cruise speed using the throt-
tle lever once the cruise function is
activated. Watercraft speed may vary
depending on water conditions during
use.
Changing Set Cruise Speed
To increase the set maximum cruise
speed:
1. Pull the throttle lever all the way to
the handlebar.
2. Press and hold the UP arrow button
on the RH handlebar until the new
desired speed is obtained.
To decrease the set maximum cruise
speed:
1. Hold the throttle lever steady.
2. Press and hold the DOWN arrow
button on the RH handlebar until
the new desired speed is obtained.
NOTE: Pressing the UP or DOWN ar-
row button repeatedly will change the
set speed in single increments. Press-
ing and holding the button will increase
or decrease the speed until the button
is released.
Deactivating Cruise Mode
To deactivate cruise mode:
1. Release the throttle lever.
2. Press the cruise button.
Deactivation of cruise mode is indi-
cated by:
– The CRUISE indicator light in the
speedometer display will go off.
– A BEEP will be heard.
NOTE: If the throttle lever is not fully
released when the cruise button is
pressed to deactivate cruise mode, the
BEEP will not be heard and the cruise
light will remain on. The speed limiting
function of cruise mode will stay active
until the throttle is fully released, then
the BEEP will be heard and the cruise
light will go out.
How to Use Slow Speed
Mode
The Intelligent Throttle Control also
allows for a Slow Speed Mode where
the driver can adjust and set idl
e speed.
This is usefull when operating in slow
94
______________