Specifications

EQUIPMENT
WARNING
Engine must be shut off before at-
tempting to board the watercraft
using the boarding step.
WARNING
Be aware of the iBR gate move-
ment when starting the engine,
shutting down the engine or using
the iBR lever. Automatic move-
ment of the gate may squeeze fin-
gers or toes of people taking a hold
on the back or your PWC.
Pull down the step with your hand and
hold until a foot or a knee is put on the
step.
smo2009-002-133
BOARDING STEP HELD DOWN FOR
BOARDING FROM WATER
NOTICE
– Never use the step for boarding a
watercraft that is out of water.
– Never use the step for pulling,
towing, diving or jumping, or
any other purpose other than as a
boarding step.
– Stay on center of the step.
– Only one person at a time on the
step.
8) Boarding Platform
A boarding platform covers the rear
deck area.
Two indentations in the platform are
used as foot rests for the rear facing
spotterwhentowingaskierortuber.
Twograbhandlesneartherearedgeof
the platform provide hand holds for a
person boarding from the water.
RXT-iS, GTX iS and GTX Limited iS
The platform also serves as a water-
tight cover for two rear storage bins
that are accessible when opening the
platform. It is hinged to the fixed deck
at the rear, and held closed by two
latches at its front corners.
To open the boarding platform, pull up
on each latch handle and lift the deck
fully up. A cylinder on the left side is
capable of holding the platform open.
smo2009-002-131_c
GTX LIMITED iS MODEL ILLUSTRATED
1. Boarding platform
2. Spotter foot rests
3. Grab handles
4. Latch handles
9) Speed-Ties
GTX Limited iS
Two speed-ties are provided for moor-
ing of the watercraft.
One speed-tie is located just below the
LH handlebar, the other is located in
the center rear edge of the boarding
platform.
_______________
77