Specifications
CONTROLS
Manually Trimming the VTS
All Except RXT 215 and GTX 155
Models
1. To manually trim the VTS, click
(press) the VTS UP or DOWN ar-
row button once to trim the VTS one
increment (up or down as selected).
2. After a short delay, click it again to
move the VTS one more increment.
Repeat previous step until desired
trim attitude is achieved.
NOTE: A total of nine trim positions
are available.
NOTE: The VTS UP or Down button
canalsobepressedandhelduntilthe
desired attitude is obtained. The jet
pump nozzle will keep moving until
the trim button is released, or the ma-
ximum trim position (up or down) is
reached.
RXT 215 and GTX 155 Models
These models are not equipped with
a VTS trim button. Refer to
VTS POSI-
TION
in
INFORMATION CENTER
for
instructions.
Using Preset Trim Positions
Two preset trim positions can be se-
lected.
To select the highest trim position
recorded, double-click on the VTS UP
arrow button (bow up).
To select the lowest trim position
recorded, double-click on the VTS
DOWNarrowbutton(bowdown).
NOTE: If only one preset trim position
is recorded, double-click either UP or
DOWN arrow of the VTS button.
sdd2009-001-019_c
DOUBLE-CLICK UP OR DOWN TO USE
PRESET POSITIONS
1. Highest preset position on UP arrow
2. Lowest preset position on DOWN arrow
Recording Preset Trim Positions
You can preset VTS positions for quick
settings when adjusting watercraft
trim.
Two different trim positions can be
recorded, one for each UP or DOWN
arrow of the VTS button. As an exam-
ple, one can be preset for operating
the watercraft with operator only, the
other for operator and a passenger.
The VTS system will compare trim set-
tings recorded, the highest position
will be assigned to the UP arrow (bow
up), the lowest to the DOWN arrow
(bow down).
If both trim positions are identical, both
buttons will have the same trim set-
tings.
During preset adjustment, any of the
9 indicated VTS positions can be se-
lected for each preset position. The
factory default settings are PRESET 1
is set to 4, and PRESET 2 is set to 5.
To record VTS preset trim positions:
1. Turn on the electrical power by
pressing the start/stop button once
without installing the D.E.S.S. key
on its post.
2. On the RH handlebar, press the
MODE button repeatedly until VTS
MODE is displayed.
54
______________