Specifications

CONTROLS
Waking Up the Electrical System
Press the start/stop button once with-
out installing the D.E.S.S. key on its
post.
This will power up the electrical sys-
tem; the information center will cycle
through a self-test function, display a
scrolling welcome message followed
by a key recognition message, and will
then go blank after a few seconds.
The electrical system will stay pow-
ered up for approximately 3 minutes
after the start/stop button was de-
pressed.
This function allows the suspension to
be activated without starting the en-
gine.
NOTE: If the start/stop button is
pressed and held without the D.E.S.S.
key installed, the information center
displays will stay on as long as the
start/stop button is held.
Engine Starting and Stopping
Refer to
OPERATING INSTRUCTIONS
forcompleteproceduretostartand
stop the engine.
6) VTS Button (Variable
Trim System)
This watercraft is equipped with a pro-
grammable high performance VTS.
It provides watercraft pitch trim adjust-
ments by adjustingthe vertical position
of the jet nozzle.
The VTS can be manually trimmed to
desired attitude, or to one of two pre-
set trim positions.
Press VTS control button (up or down
arrow) to adjust riding attitude of the
watercraft.
sdd2009-001-019_c
TYPICAL - VTS CONTROL BUTTON
1. Bow up
2. Bow down
Watercraft trim position can be seen
on the VTS position indicator in the in-
formation center digital screen.
NOTE: Changing the VTS trim position
without the engine running in forward
thrust mode only changes the indica-
tion. The nozzle will then move to the
selected VTS trim position when for-
ward thrust is engaged.
sdd2009-001-042_a
INFORMATION CENTER — VTS POSITION
INDICATOR
1. Bow up
2. Bow down
NOTE: Only the segment indicating
the relative position of the VTS will
be on. The illustration shows all seg-
ments on as visible during the self test
function.
_______________
53