Specifications

PRE-RIDE INSPECTION
WARNING
Should the D.E.S.S. key be loose or
fail to remain on its post, replace it
immediately in order to avoid un-
safe use. If removing the lanyard
or pressing the start/stop button
does not stop the engine, do not
use the watercraft. See your au-
thorized Sea-Doo dealer for sys-
tem testing and repairs.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM OPERATION
✓
Information Center
Check
operation.
Intelligent Brake and
Reverse System
(iBR)
Check
operation.
Variable Trim System
(VTS)
Check
operation.
Information Center (Gauge)
1. Press start/stop button and install
D.E.S.S. key.
2. As information center cycles
through its self-test function, en-
sure all indications and indicator
lights come on.
WARNING
Attach the safety lanyard to your
PFD.
iBR System
NOTICE
Ensure there is sufficient
space ahead and behind watercraft
to safely carry out the iBR sys
tem
test to avoid a collision. Watercraft
will move during test.
1. Remove the moorings securing the
watercraft to the dock.
2. Start the engine and ensure the wa-
tercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the wa-
tercraft should move slowly back-
wards.
4. Release the iBR lever, there should
not be any reverse thrust.
WARNING
Always ensure proper iBR system
operation before taking the water-
craft out for a ride.
Variable Trim System (VTS)
All Except RXT 215 and GTX 155
Models
Withtheenginerunninginforward
thrust, push the VTS up/down arrow
button alternately to check VTS op-
eration. Confirm the VTS position in-
dicator movement in the information
center.
Test also the VTS preset trim positions
by double clicking the VTS UP/DOWN
button.
RXT 215 and GTX 155 Models
1.Withtheenginerunninginforward
thrust, press the MODE button re-
peatedly until VTS is visible in the
multifunction display.
2. On the RH handlebar, press the UP
or DOWN arrow button alternately
to change the VTS setting.
3. Confirm VTS operation by looking
for the VTS position indicator move-
ment in the digital display.
4. Press the SET button to save the de-
sired setting and return to the main
display.
________
SAFETY INF
ORMATION
________
39