Specifications

MONITORING SYSTEM
Beeper Code Information
BEEPER CODES DESCRIPTION
Bad D.E.S.S. system connection.
Reinstall D.E.S.S. key correctly over post.
Wrong D.E.S.S. key.
Use a D.E.S.S. key that has been programmed for the
watercraft.
Defective D.E.S.S. key.
Use another programmed D.E.S.S. key.
Dried salt water in D.E.S.S. key.
Clean D.E.S.S. key to remove salt water.
Defective D.E.S.S. post.
Refer to an authorized Sea-Doo dealer.
1LongBeep
(while installing D.E.S.S.
key on watercraft post)
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES .
A 2 Seconds Beep
every 15 minutes interval
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
A 2 Seconds Beep
every 5 minutes interval
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
High engine temperature coolant.
See
ENGINE OVERHEATING .
High exhaust temperature.
Refer to an authorized Sea-Doo dealer.
Continuously Beeps
Low oil pressure.
Turn off engine as soon as possible. Check oil level and
refill. Refer to an authorized Sea-Doo dealer.
NOTICE
If the monitoring beeper continuously sounds, stop engine as
soon as possible.
______________
149