Specifications

TROUBLESHOOTING GUIDELINES
ENGINE WILL NOT START
1. D.E.S.S. key removed.
– Install D.E.S.S. key over post.
2. ECM does not recognize the D.E.S.S. key.
– Refer to an authorized Sea-Doo dealer.
3. Burnt fuse: main, electric starter or ECM.
– Check wiring then replace fuse(s).
4. Discharged battery.
– Refer to an authorized Sea-Doo dealer.
WARNING
Do not charge or boost the battery while installed on the watercraft. Elec-
trolyte is poisonous and dangerous. Avoid contact with eyes, skin and
clothing.
5. Battery connections, corroded or loose. Bad ground.
– Refer to an authorized Sea-Doo dealer.
6. Water-flooded engine.
– Refer to WATER-FLOODED ENGINE in SPECIAL PROCEDURES.
7. Faulty sensor or ECM.
– Refer to an authorized Sea-Doo dealer.
8. Seized jet pump.
– Try to clean. Otherwise, refer to an authorized Sea-Doo dealer.
ENGINE TURNS SLOWLY
1. Loose battery cable connections.
– Check/clean/tighten.
2. Discharged or weak battery.
– Refer to an authorized Sea-Doo de
aler.
3. Worn starter.
– Refer to an authorized Sea-Doo dealer.
ENGINE TURNS NORMALLY BUT WILL NOT START
1. Fuel tank empty or water-contaminated.
– Refill. Siphon and fill with fresh fuel.
2. Fouled/defective spark plugs.
–Replace.
3. Blown fuse.
– Check wiring then replace fuse(s).
4. Water-flooded engine.
– Refer to WATER-FLOODED ENGINE in SPECIAL PROCEDURES.
142
______________