Specifications
STORAGE AND PRESEASON PREPARATION
Storage
WARNING
Because fuel and oil are
flammable, have an authorized
Sea-Doo dealer inspect the fuel
system integrity as specified in the
periodic inspection chart.
It is recommended that the watercraft
be serviced by an authorized Sea-Doo
dealer for storage, however the follow-
ing operations can be performed by
you with a minimum of tools.
NOTE: Carry out the following tasks in
the same order as detailed in this sec-
tion.
NOTICE
Do not run the engine dur-
ing the storage period.
Fuel System Protection
Sea-Doo XPS fuel stabilizer (or equiva-
lent) should be added in the fuel tank to
prevent fuel deterioration and fuel sys-
tem gumming. Follow stabilizer manu-
facturers' instructions for proper use.
NOTICE
It is highly recommended
to add fuel stabilizer at storage in or-
der to maintain fuel system in good
condition. Fuel stabilizer should
be added prior to engine lubrica-
tion and fuel tank top up to ensure
fuel system components protection
against varnish deposits.
Exhaust System Flushing
Perform procedure as described in
MAINTENANCE PROCEDURES
.
Engine Oil and Filter Replacement
The oil change and filter should be
performed by an authorized Sea-Doo
dealer.
Intercooler Draining
RXT-iS,RXT-XandGTXLimitediS
Models
It is important to expel any trapped wa-
ter that may have accumulated from
condensation in the intercooler.
Proceed as follows:
1. Open the boarding platform and re-
move the RH storage bin.
2. Ensure there is an alignment line
drawn on the intercooler outlet
hose. This will ensure the hose is
not twisted or kinked on reinstalla-
tion.
3. Loosen the clamp retaining the in-
tercooler outlet hose.
4. Remove the intercooler outlet hose
from the intercooler.
NOTE: This hose feeds the inlet of the
throttle body.
5. For RXT-iS and GTX Limited iS mod-
els, drape a couple of shop rags or
a plastic bag over the iS module to
protect it from any expelled water
from the intercooler.
smo2009-002-151_a
TYPICAL - RXT-iS MODEL ILLUSTRATE
D
1. Hose alignment lines
2. Hose clamp
3. Intercooler outlet hose
4. iS module
6. Start and rev the engine up to
4000 RPM several times.
128
______________