Specifications

MAINTENANCE PROCEDURES
smo2009-002-114_ff
SECOND AVAILABLE MODE FUNCTION- IBR
OVR MODE
5. Press the SET button to enter IBR
OVR function and display OVR OFF.
smo2009-002-114_hh
MODE FUNCTION ENTERED- OVR OFF
6. Press the UP or DOWN arrow but-
ton (RH handlebar) to display OVR
ON.
smo2009-002-114_gg
MODE FUNCTION ACTIVATED- OVR ON
7. Press the SET button to select the
OVR ON function. The gauge will
return to its normal display.
8. Press the VTS UP or DOWN arrow
buttontomovetheiBRgate.
There are three ways to deactivate the
iBR override function:
1. Repeat previous steps and press
the SET button when OVR OFF is
visible.
2. Wait for the electricalpower to shut
off.
3. Start the engine.
NOTE: When the engine is started,
the iBR OVR function is deactivated
and the iBR gate will move to the neu-
tral position.
WARNING
When moving the iBR gate using
the iBR override function, ensure
nobody stands near the rear of the
watercraft. Movement of the gate
may squeeze fingers.
Ski/Wakeboard Post
(Wake)
Ski/Wakeboard Post Inspection
Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wakeboard post and see an autho-
rized Sea-Doo dealer for repair.
Ski/Wakeboard Post Lubrication
Clean ski/wakeboard post and apply
a light coat of SUPER LUBE GREASE
(P/N 293 550 030).
Lubricate post throughout its length.
Wipe off all excess grease and reinstall
post.
Extend and retract several times to dis-
tribute the lubricant.
124
______________