Specifications

MAINTENANCE PROCEDURES
provides for an iBR override function
which, is accessible through the infor-
mation center.
When iBR override is activated, it al-
lows the user to electrically move the
iBR gate and nozzle through its full
range of motion using the VTS control
button.
NOTE: The iBR override function is
only available when the engine is not
running.
WARNING
When moving the iBR gate using
the iBR override function, ensure
nobody stands near the rear of the
watercraft. Movement of the gate
may squeeze fingers.
NOTICE
An object or tool caught
in the iBR system when using the
iBR override function may cause
damage to the iBR components. Re-
move all rigid foreign objects that
may obstruct the iBR gate travel be-
fore moving it.
WARNING
If it is necessary to reach in to re-
move any foreign object caught
in the iBR gate, nozzle or linkages,
strictly observe the following be-
fore proceeding:
– Remove D.E.S.S. key from post.
– Waitatleast5minutes.
– Do not press on start/stop but-
ton. If ever start/stop button is
pressed, wait 5 minutes again.
iBR Override Function
To activate the iBR override function,
carry out the following ste
p.
1. Power up the electrical system by
pressing the start/stop
button and
then installaing the D.E.S.S. key.
NOTE: The D.E.S.S. key must be in-
stalledtoensuretheinformationcen-
ter will not shut off all indications after
its self test function. Electrical power
will stay for approximately 3 minutes.
2. Press the Mode button on the RH
handlebar repeatedly until SET-
TINGS is visible in the digital display
of the information center.
smo2009-002-114_y
FUNCTION SELECTED - SETTINGS
3. Press the SET button (RH handle-
bar) to display DOCK MODE.
smo2009-002-114_bb
FIRST AVAILABLE MODE FUNCTION- DOCK
MODE
4. Press the UP or DOWN arrow but-
tontodisplayIBROVR.
______________
123