Specifications

MAINTENANCE PROCEDURES
smo2009-002-139_a
TYPICAL
1. Hose adapter (optional, not mandatory)
2. Quick connect fitting (optional, not
mandatory)
3. Garden hose
To flush, start engine then immediately
open the water tap.
CAUTION Certain compo-
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn. Do not touch
any electrical parts or jet pump area
when engine is running.
NOTICE
Never flush a hot en-
gine. Always start the engine before
opening the water tap. Open wa-
ter tap immediately after engine is
started to prevent overheating.
Run the engine about 20 seconds at a
fast idle between 4000 - 5000 RPM.
NOTICE
Never run engine without
supplying water to the exhaust sys-
tem when watercraft is out of water.
Ensure water flows out of jet pump
while flushing. Otherwise, refer to an
authorized Sea-Doo dealer for servic-
ing.
NOTICE
Never run engine longer
than 2 minutes. Drive line seal has
no cooling when watercraft is out of
water.
Close the water tap, then stop the en-
gine.
NOTICE
Always close the water
tap before stopping the engine.
NOTICE
Remove quick connect
adapter after flushing operation (if
used).
RidePlateandWaterIntake
Grate
Ride Plate and Water Intake Grate
Inspection
Inspect ride plate and jet pump wa-
ter intake grate for damage. See your
Sea-Doo dealer to have any damaged
part repaired or replaced.
WARNING
The D.E.S.S. key must always be
removed from its post prior to in-
specting the intake grate.
F18J04Y
21
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
Jet Pump, Nozzle and iBR
Gate
To permit easy access to the jet
pump,
nozzle, iBR gate, and various linkages
for inspection, maintenance, cleaning
or removal of debris, the iBR
system
122
______________