Specifications

MAINTENANCE PROCEDURES
RXTiS,GTXiS,andGTXLimitediS
Models
3. Remove the ventilation box from
thedeckextensiontogainpartial
access to engine compartment.
NOTE: To remove the ventilation box,
simply release the 3 clips retaining it
and lift it off the deck extension.
smo2009-002-002_a
1. Ventilation box
2. Deck extension
3. Retaining clips
All Models
4. Install a garden hose on the exhaust
system flushing connector. Refer
to
EXHAUST SYSTEM in this sec-
tion and follow the procedure.
NOTICE
– Never run engine without supply-
ing water to the exhaust system.
Failure to cool exhaust system
may severely damage it.
– Never run engine longer than
2 minutes. Drive line seal has no
cooling when watercraft is out of
water.
5. With the engine already at normal
operating condition, let engine idle
for 30 seconds then stop engin
e.
6. Wait at least 30 seconds for the oil
to settle in the engine, t
hen pull dip-
stick out and wipe clean.
smo2009-002-003_b
TYPICAL - RXT iS ILLUSTRATED
1. Oil dipstick location
7. Reinstall dipstick, push in com-
pletely.
8. Remove dipstick again and read
oil level. It should be between the
FULL and ADD marks.
lmr2007-053-100_a
1. Full
2. Add
3. Operating range
9. Add oil to ensure the level is be-
tween marks as required.
To add oil:
– Unscrew oil cap.
– Place a funnel in the oil filler neck
opening.
– Add the recommended oil to the
proper level.
NOTE: Do not overfill.
______________
117