Specifications

MAINTENANCE PROCEDURES
This section includes instructions for
basic maintenance procedures. If you
have the necessary mechanical skills
and the required tools, you can per-
form these procedures. If not, see
your authorized Sea-Doo watercraft
dealer.
WARNING
Turn off the engine and follow
these maintenance procedures
when performing maintenance.
If you do not follow proper main-
tenance procedures you can be
injured by hot parts, moving parts,
electricity, chemicals or other haz-
ards.
WARNING
Should removalof a locking device
(e.g. lock tabs, self-locking fasten-
ers, etc.) be required, always re-
place with a new one.
NOTICE
Never leave any object,
rag, tool, etc., in the engine com-
partment or in the bilge.
Ignition Coils
Ignition Coil Removal
1. Open seat.
2. Remove engine cover (as applicable
to model).
Disconnect ignition coil connector.
NOTICE
Do not remove the igni-
tion coil before disconnecting the
input connector or the wires may be
damaged. Do not pry up ignition coil
with a screwdriver to avoid damage.
NOTE: Twist ignition coil in both direc-
tions as you pull it up to ease removal.
Remove ignition coil from spark plug.
Ignition Coil Installation
1. Pull rubber seal down.
sbs2009-011-002_a
1. Rubber seal pulled down
2. Apply DOW CORNING 111 (P/N 413
707 000) to rubber seal seat as
shown.
smr05-015-002_d
1. Apply product here
sbs2009-011-001_a
1. Apply product here
3. Pull rubber seal back on its
seat
making sure the tabs on the ignition
coil and the slots in the seal properly
match together.
4. Leave a ring of grease on top of the
seal as shown to act a
s a water bar-
rier. Wipe off the excess.
______________
115