Specifications

OPERATING INSTRUCTIONS
WARNING
Your PWC is equipped with an in-
telligent suspension. Although
the system absorbs part of the ver-
tical forces and therefore reduces
the impact force to the body, it can-
not eliminate it completely. To
prevent you and your passenger
from being bounced and eventu-
ally ejected from the watercraft,
reduce your speed.
WARNING
Avoidridinginveryroughwaters
or practicing extreme maneuvers
like jumping wakes or waves.
Automatic Suspension Mode
When the engine has been operat-
ing at a predetermined RPM for a given
time, the suspension will automatically
move up to a factory preset height.
This height is ideal for most riding con-
ditions at cruising speeds.
The iS system constantly monitors the
stroke of the suspension and automat-
ically compensates for changing water
conditions and passenger load.
Whenthemovingdeckisraisedabove
the hull, it proportionally elevates the
center of gravity of the watercraft
higher above the water.
If the watercraft slows down below
a predetermined RPM for a given
time, the suspension will automatically
loweritselftoDOCKMODEheight.
If the watercraft is operated above a
predetermined RPM for a given time
and put into a hard braking turn with
the handlebars turned fully to the left
or right, the suspension will lower it-
self to DOCK MODE height to lower
the center of gravity.
NOTE: When performing certain
ma-
neuvers at low speed the watercraft's
propensity to overturn can increase.
Manual Suspension Mode
MANUAL SUSPENSION mode allows
fine-tuning the suspension calibration
to the operator's preference. The sus-
pension height canbeadjustedusing
the iS button (UP or DOWN arrow) on
the left handlebar.
Suspension height can be adjusted a
total of nine increments.
NOTE: Changing the suspension
height using the iS button puts the
iS system in MANUAL SUSPENSION
MODE. The suspension will remain in
MANUAL SUSPENSION MODE un-
til selected to AUTO SUSPENSION
MODE, or until the watercraft is shut
downandpoweredupagain.
If the suspension is being used in
MANUAL SUSPENSION mode and
youwishtorevertbacktoAUTO-
MATIC SUSPENSION mode by dou-
ble-clicking the iS button (UP or DOWN
arrow). Refer to the
CONTROLS sub-
section for more details.
Dock Mode
The iS system can be set to DOCK
MODE AUTO or DOCK MODE OFF.
Dock Mode AUTO
In DOCK MODE AUTO, the suspen-
sion lowers to DOCK mode height to
lower the center of gravity when cer-
tain conditions are met.
– When the engine is shut down after
normal operation of the watercraft
(always).
– If OTAS is activated.
– If the operator releases the throt-
tletoidleRPMforapproximately
10 seconds, after operating at or
above a calibrated RPM for a given
period of time.
NOTE: When the suspension moves
down to dock mode height, a DOCK
MODE ON message will scroll acros
s
in the multifunction display.
100
______________