Instruction manual

Document # 82070-1026, Revision B CONFIDENTIAL © 2011 Copyright VTS Medical Systems, LLC
11 of 32
Remote Control
Overview of Remote Control Functions
Figure 7: The Remote
Control
Key Description
Power Turn the monitor on and off
Source Displays and selects the available input sources
SDI Switches the input signal to SDI
HDMI Switches the input signal to HDMI
DVI-D/DVI-A Switches the input signal to DVI-D or DVI-A
S-VIDEO Switches the input signal to S-Video
Composite Switches the input signal to Composite
DisplayPort Switches the input signal to DisplayPort
RGB Switches the input signal to RGB
YPbPr Switches the input signal to YPbPr
VGA Switches the input signal to VGA
PIP POS
(Position)
When the PIP mode is enabled, adjusts the position of the
secondary image
PAP Enters and exits Picture-And-Picture (PAP) mode
PIP Enters and exits Picture-In-Picture (PIP) mode
MENU Display the OSD menu screen
SWAP
When using PIP and PAP, swaps the PIP or PAP image
source with the main image source.
ENTER Go to the next step or confirm the OSD setting
Navigate on screen menus
EXIT Exit the OSD menu
AUTO
Automatically adjust image Clock, Phase, H-Position, V-
Position settings
USER1 - USER5
Load a user profile. Note that the default user names
(User 1 – 5) used on the remote control may have been
changed to custom names in the OSD menus.
INFO Display on-screen information about the monitor
FUNC-A Color Temp. Selection
FUNC-B Gamma Selection
FUNC-C Mode Selection
Table 4: Remote Control Functions
Changing the Remote Control Battery
1. Remove the battery cover by pulling then lifting the knob on the cover.
2. Insert the batteries, corresponding to the positive (+) and negative (-) marking on the battery compartment
3. Reattach the battery cover.
Figure 8: Remote Control Battery Access