Use Guide

common problem.
1. When using this product for the first time, please fully cha
2. Remote monitoring is not smooth. Please choose the suitable
clarity according to the network environment at that time.
3. The memory card does not save video, and it must be formatted
the first time the memory card is used.
4. The default password of the camera is 6666. If you forget the user
name or password, you can restore the camera to factory settings to
get the default user name and password.
5. The camera is restored to its factory settings. Press the reset
button of the camera for about 5 seconds until the camera restarts.
6. Why is the image blurry? Remove the protective film of the lens. If
it is still not clear, please rotate the camera lens and focus. After
focusing, a clear image can be obtained.
7.APP can't search to detect camera/can't configure network, please
make sure the device is connected properly and check App Use
permission is not restricted.
If the application always shows failure, try
checking the following items:
A. It supports ordinary routers, and public routes that require login
page authentication are temporarily not supported.
B. When configuring, note that the network name, network password
and UID are not incorrect.
C. Chinese Wifi names and passwords and special symbols are not
supported at the moment.
D. Wifi signal that does not support 5G
E. The device is not online and the red light is always on, indicating
that the camera is connected to the network successfully, probably
because the App permissions are not open. Please check whether to
open.
F. If WiFi is WEP encryption mode, please change it to WPA mode.