User’s Manual 2-in-1 Baby Activity Walker 6-36 Months © Disney Based on the “Winnie the Pooh” works by A.A. Milne and E.H. Shepard. Visit the Disney website at www.
INTRODUCTION Thank you for purchasing the VTech® 2-in-1 Baby Activity Walker! Handle Play/Music mode selector Spinning flower mirror On/Off/Volume control switch Bee button Light-up button Introduction The 2-in-1 Baby Activity Walker will entertain your little one from sitting to walking. Easy grip handle, textured wheels and durable design help encourage those precious first steps.
INCLUDED IN THIS PACKAGE - One Electronic Activity Panel One Main Walker Body Two Legs with Wheels One Walker Handle One User’s Manual NOTE: Please keep user’s manual as it contains important information. BATTERY INSTALLATION 1. Make sure the unit is turned OFF. 2. Locate the battery cover on the back of the unit. Use a coin or a screwdriver to loosen the screw. 3. Install 2 new ‘AA’ (AM-3/LR6) batteries following the diagram inside the battery box.
• • • • • • • • • Rechargeable batteries are to be removed from the toy before being charged (if removable). Rechargeable batteries are only to be charged under adult supervision (if removable). Do not mix old and new batteries. Do not mix batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity.
2. Insert the legs into the slots with the wheels facing outward, as shown in the diagram. 4. Stand the walker upright and insert the handle into the slots on the top to secure the legs. 5. Push and screw in the fasteners at the top of the walker to secure the handle and legs. Assembly Instructions 3. Gently pull the legs back until they click into place. Please ensure the legs are fully inserted into the slots. Attaching/Removing the Activity Panel 1.
2. To remove the activity panel, locate the red release lock above Pooh’s head. Slide the lock up and lift the activity panel, removing it from the walker. 1. ON/OFF/VOLUME CONTROL SWITCH To turn the unit ON, slide the ON/OFF/ VOLUME CONTROL SWITCH to the LOW VOLUME ( ) or the HIGH VOLUME ( ) position. To turn the unit OFF, slide the ON/OFF/ VOLUME CONTROL SWITCH to the OFF ( ) position. 2.
ACTIVITIES 1. Slide the ON/OFF/VOLUME CONTROL SWITCH to turn the unit ON. You will hear a song, fun sounds and a phrase. The light will flash with the sounds. 3. Move the SLIDING CATERPILLAR to hear fun sounds, a short tune and phrases in Play Mode or a fun sound and a melody in Music Mode. The light will flash with the sounds. Activities 2. Press the BEE BUTTON to hear fun sounds and phrases in Play Mode or a fun sound and a melody in Music Mode. The light will flash with the sounds. 4.
6. Move the ROLLER BALL to hear fun sounds and phrases in Play Mode or fun sounds and a melody in Music Mode. The light will flash with the sounds. 8. Push the walker with the activity panel attached and turned on to activate the MOTION SENSOR. You will hear fun phrases, songs, a short tune and melodies. The light will flash with the sounds. The MOTION SENSOR is located inside the activity panel. 9. When a melody is playing, press the buttons or move the features to jam in fun sounds.
CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 3. Remove the batteries when the unit will not be in use for an extended period of time. 4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water. TROUBLESHOOTING If for some reason the program/activity stops working or malfunctions, please follow these steps: 1. Please turn the unit off. 2. Interrupt the power supply by removing the batteries. 3.
IMPORTANT NOTE: Creating and developing Infant Learning products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department at 1-800-521-2010 in the U.S.
Other Info This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ices-003. Cet appareil numérique de la classe b est conforme à la norme nmb003 du Canada.
