User's Manual

4
Getting started
Add and register a handset (optional)
Each newly purchased handset (LS6204) must be registered to your
telephone system (LS6245) before use. When rst purchased, each
expansion handset shows NOT REGISTERED. You may need to charge
the handset before registering to the telephone base. For more details on
battery charging, see the table on page 3.
To register a handset:
Place the unregistered handset in the telephone base. If To register,
press HOLD on BASE for 4 sec does not appear on the handset screen
after a few seconds, remove the handset and place it in the telephone
base again.
On the telephone base, press and hold HOLD for about four seconds until
the telephone base displays Registering handset. The handset shows
Please wait... and it takes up to 60 seconds to complete the registration.
The handset shows HANDSET X Registered (X represents the handset
number assigned) and you hear a beep when the registration completes.
1.
2.
If the registration fails, the handset shows NOT REGISTERED. To reset
the handset, remove the handset from the telephone base and place it back
in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
•
•