Operating instructions

6
wallboard
wooden
stud
WALL MOUNTING
4.Connect the telephone cord. The
telephone line cord has a snap-in plug at
each end. Insert one of the plugs into the
jack on the bottom of the base. Insert the
other end of the plug into the wall jack.
5.Connect the power cord. Plug the DC
connector into the DC jack at the rear of
the base unit. Plug the AC power adapter
into an electrical outlet.
6.Set the dial mode switch on the base
unit. If you have touch tone service on your
phone line, set the switch to TONE. If you
have rotary service, set the switch to
PULSE.
1.Choose a spot near an electrical outlet
and a telephone jack.Your phone requires
a modular telephone jack and a standard
electrical outlet (120V AC). The power cord
is six feet long; make sure there is an
electrical outlet within reach of the base.
The outlet should not be controlled by a
wall switch. If the switch is ever turned off,
the phone will not operate.
2.Position the wall mount adapter on the
base. Line up the tabs on the wall mount
adapter with the holes on the bottom of
the base. Snap the wall mount adapter
firmly in place.
3.Mount the base on the wall. Position the
base so the mounting studs will fit into the
holes on the bottom of the base. Position
the power cord to extend down the wall
the phone is to be mounted on. Slide the
base down on the mounting studs until it
locks into place.