Operating instructions

11
USING THE WALL MOUNT
ADAPTOR
1. Position the wall mount bracket
on the Base Unit.
Line up the tabs on the wall mount
adaptor with the holes on the bottom
of the Base Unit . Snap the wall
mount bracket firmly in place.
xxx xx xx xxxxxx xxx
PRODUCT CONTAINS NICKEL-CADMIUM BATTERY:
MUST BE RECYCLED OR DISPOSED OF PROPERLY.
DO NOT BURN OR PUNCTURE BATTERY. LIKE
OTHER BATTERIES OF THIS TYPE. IF IT IS BURNED
OR PUNCTURED. IT COULD RELEASE TOXIC
MATERIAL WHICH COULD CAUSE INJURY.
Cd
2. Mount the Base Unit on the wall.
Position the Base Unit so the
mounting studs will fit into the holes
on the bottom of the Base Unit.
Position the power cord to extend
down the wall the phone is to be
mounted on. Slide the Base Unit
down on the mounting studs until it
locks into place.
3. Plug in the AC adaptor.
Plug the AC adaptor into an electrical
outlet, and the DC connector to the
back of the Base Unit. If the Handset
battery pack has not been charged
previously,
place the Handset in
the Base Unit cradle, and allow it
to
charge for 16 hours.
WALL MOUNTING
xxx xx xx xxxxxx xxx
PRODUCT CONTAINS NICKEL-CADMIUM BATTERY:
MUST BE RECYCLED OR DISPOSED OF PROPERLY.
DO NOT BURN OR PUNCTURE BATTERY. LIKE
OTHER BATTERIES OF THIS TYPE. IF IT IS BURNED
OR PUNCTURED. IT COULD RELEASE TOXIC
MATERIAL WHICH COULD CAUSE INJURY.
Cd
4. Connect the telephone line cord.
The telephone line cord has a
snap-in plug at each end. Insert one
of the plugs into the jack on the
bottom of the Base Unit. Insert the
other end of the plug into the wall
jack.