User`s manual

www.vtech.com
25
If you have difficulty with your phone, please try the suggestions listed below:
Problem Cause Solutions
No dialing tone when pressing
key
a. The connection cord of the
base station is not plugged in.
b. The a dap t e r c o r d i s n o t
plugged in correctly in the
base station.
c. The line is busy, as another
handset is used.
d. Wrong connection cord (no
Euro AS)
a. Check the connections. Unplug
.sniam eht ni kcab gulp dna
Check that the telephone line
cord has been plugged into
the base station and the phone
socket.
b.
Check the base station power
jack and the adaptor plug
(remove an plug-in).
c. W a i t u n t i l t h e l i n e i s
unoccupied.
d. Use th
e original connection
cord.
When connect to a PBX, no and/or
wrong connection after dialing.
Dialing prefix is needed. Insert the dialing prefix
“SEARCHING” is displayed.
a. Base station out of range.
b. Base station not connected
to mains.
Reduce the range.
Connect base station to mains.
The call does not work.
Service not activated or wrong
operator or wrong setting
Check your Subscription with
network or change the dial
mode.
No display.
Empty battery Recharge battery
Please contact
the technical support of the network provider for further information.
This telephone is not equipped with a grounding function! Therefore some of the functions may be limited when
used in PBX systems. For technical support, call VTech Technical Inquiry Hotline Tel: [phone].
Troubleshooting