Specifications

DELETING NUMBERS
Pressing the CLRIDEL button deletes
the CID number displayed.
While the phone is in CID mode,
press the
(cLR/DEL key once to
delete the current call and the
display will show:
\
The older CID number will be
moved forward by one location
.
Press and hold the (cmq key
for more than 2 seconds to delete
the entire contents of CID memory.
The display will show the following,
for a final confirmation, before the
entire CID memory is erased:
Pressing any key other than
(CLR/DEL)will cancel the operation.
Pressing
(-9 will confirm
the operation and the display will
then show:
The message will remain on the
display for 2 seconds.
NOISE OR INTERFERENCE
Your VTech VT 1910c cordless
telephone has auto-channel scan
circuitry which will detect excess noise
i
and change the channel of the phone
to reduce it. This is done automatically.
Since the VTech VT 1910c is a fully
digital phone, it does not suffer from
noise associated with regular cordless
phones. At times you may experience
occasional "drop outs" especially at the
extreme edges of the phone's
range.
Simply move closer to the base unit
and this will disappear.
AUTOMATIC SECURITY CODING
Your VTech VT 191 0c phone is factory
set with
16.8 million possible security
codes. This unique security code
allows your handset and base to
recognize each other, and minimizes
the possibility of another cordless
phone using your telephone line.
OUT OF RANGE INDICATION
If the handset is moved to a point where
the base and handset can no longer
communicate, the handset will make a
quick series of beeps to signal Out of
Range.
If the handset is active when taken
out-of-range, it will beep twice a
second and enter standby mode after
25 seconds if the link is not
reestablished. If the handset is
brought back within range, it will
automatically re-link.
P
For out-of-range in standby mode, the
handset will beep once and then at 15
second intervals, will display
"CHANNEL SERACHING" on the
LCD, and scan all channels in an
attempt to re-link with the base.
OUT OF RANGE WHEN PHONE IS
ON
If you are presently engaged in aphone
conversation move closer to the base.
If the base unit does not communicate
with the handset within 25 seconds of
losing contact, it will automatically
hang up.
OUT OF RANGE WHEN PHONE IS
OFF
If the phone is OFF, the handset and
base still monitor each other to make
sure that they can communicate. If the
handset is moved out of range, the
handset will make a series of beeps,
and will then display
"CHANNEL
SERACHING"
on the LCD. At 15
second intervals the handset will scan
all channels in an attempt to reestablish
communication with the base. This
process does not require user
intervention; the handset will re-link
with the base automatically once it is
brought back within range. The unit
will then be able to receive and place
calls.
When the base unit is unplugged from
the power supply, the handset will give
the "Out of Range" warning beep. Plug
the base in again and this will stop.