Quick Start Manual

13
6. Align the upper wall mounting hole on the back of the phone with the upper
tab of the standard wall plate. Make sure the lower wall mounting hole on the
mounting bracket also aligns with the lower tab of the standard wall plate.
Push the phone down until it clicks securely in place.
7. Bundle the Ethernet cable and power adapter cord neatly with twist ties.
8. Plug the Ethernet cable into the router your console is connected to and the
power adapter into an electrical outlet not controlled by a wall switch if you
are not using PoE.
Wall mount to tabletop installation
To change the phone from the wall mount position to tabletop position, follow the
steps below.
1. If the Ethernet cable and power adapter cord are bundled, untie them rst.
2. Push the phone up to remove it from wall. Unplug the Ethernet cable from
the router and the power adapter from the power outlet.
3. See “Installing the phone” on pages 10 to 12.