Quick Start Manual

11
5. Plug one end of the Ethernet cable into the Ethernet port on the rear of the
deskset (marked by
), and plug the other end of the cable into your
network router or switch.
If the deskset is not using power from a PoE-capable network router or switch:
a. Connect the supplied power adapter to the deskset power jack.
b. Plug the power adapter into an electrical outlet that is not controlled by a
wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a
replacement power adapter, visit our website at
businessphones.vtech.com or call 1 [phone].
2. The power adapter is intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Router
Plug the other end of
the Ethernet cable into
the router connecting
to your console.
Route the Ethernet
cable and power cord
through these slots.
Plug one end of the Ethernet cable into
the Ethernet port at the back of the phone.
Plug the small end
of the phone power
adapter into the power
jack at the back of the
phone (if PoE cannot
be provided through
Ethernet cable).
Plug the large end
of the phone power
adapter into an
electrical outlet not
controlled by a wall
switch (if PoE cannot
be provided through
Ethernet cable).