Owner's Manual

VSP735 Administrator and Provisioning Manual
16 Using the Phone Menu
Back Select
Network setting
1.DHCP
2.Set static IP
3.VLAN ID
4.Others
2. Press  or  to highlight the desired option, and then press SELECT:
 DHCP
 Set static IP
 VLAN ID
 Others (DNS and NTP servers).
To enable or disable DHCP:
1. From the Network setting menu, press  or  to highlight DHCP, and then press
SELECT.
2. Press  or  to select Enabled or Disabled, and then press Save.
DHCP is enabled by default, which means the deskset will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the deskset.
NOTE: You must be familiar with TCP/IP principles and protocols to configure static
IP settings.
To set static IP for the deskset:
1. From the Network setting menu, press  or  to highlight Set static IP, and
then press SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an
error message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot soft key to enter characters. Press  or  to advance to the next
character.
Cancel Save
Set static IP
IP: 0.0.0.0
Backspc Add dot
Subnet Mask: 0.0.0.0
Gateway: 0.0.0.0