User's Manual

Registering the handset to the base

The handset must be registered to the base station in order to make and receive

calls.

To register the handset:

1. Make sure the handset has a charged battery before

proceeding. Make sure the base station is connected to power.

2. Press MENU on the handset. The Main Menu appears.

3. Press q to scroll to User settings and press SELECT.

4. Press q to scroll to Registration and press SELECT.

5. With Handset highlighted, press SELECT. The handset

screen displays instructions. Press

to continue

reading the instructions.

6. On the base station, press the HANDSET LOCATOR button

for at least four seconds, then release the button. Both LEDs

on the base station begin to ash.

7. Press the # key on the handset. The screen shows Please

wait... The process takes up to 10 seconds to complete. When

the rst handset registers, it beeps and the screen displays

HANDSET 1.

If the handset fails to register, place it in the charger again for a

few seconds, remove it and repeat the registration procedure.

BACK ENTER

User settings

Main Menu

Status

Features

Intercom

BACK ENTER

Registration

User settings

Edit VLAN ID

Edit PIN code

Key Tone

Press and

hold HANDSET

LOCATOR key

at base for

4 seconds

LINE MENU

11:26

PM 01/01

HANDSET