Specifications

VSP600/VSP601 Administrator and Provisioning Manual
28 WebUI: Network
WebUI: Network
You can set up the base station for your network configuration on the Network
settings page. Your service provider may require you to configure your network to be
compatible with its service, and the base station settings must match the network
settings.
The network settings are also available as parameters in the configuration file. See
“network” Module: Network Settings on page 71.
Af
ter entering information on this page, click
to save it.
Basic Network Settings
NOTE: If you disable DHCP on this page, you must configure static IP settings for
the base station. You must be familiar with TCP/IP principles and protocols to
configure static IP settings.
Basic Network Settings
Click the link for each setting to see the matching configuration file parameter in
Appendix A: Configuration File Settings. Default values and
ranges are listed there.
Setting Description
Enable DHCP DHCP is selected (enabled) by default, which means the base station
will get its IP address, Subnet Mask, Gateway, and DNS Server(s)
from the network. When DHCP is disabled, you must enter a static IP
address for the base station, as well as addresses for the Subnet
Mask, Gateway, and DNS Server(s).
IP Address If DHCP is disabled, enter a static IP address for the base station.
Subnet Mask Enter the subnet mask.
Gateway Enter the address of the default gateway (in this case, your
router).
Primary DNS
Secondary DNS
If DHCP is disabled or you don’t wish to use the DHCP-assigned
DNS server (or one specified by your service provider), enter
addresses for the primary and secondary DNS servers.