Quick Start Manual

13
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at
businessphones.vtech.com
or call 1 [phone].
2. The power adapter is intended to be correctly oriented in a vertical or oor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
Battery installation and charging
Install the battery as shown on the following page. Once you have installed the battery,
the screen indicates the battery status (see the table below). If necessary, place
the handset in the charger to charge the battery. For best performance, keep the
handset in the charger when not in use. The battery is fully charged after 11 hours of
continuous charging.
If the screen is blank, you need to charge the handset without interruption for at least
30 minutes to give the handset enough charge to use the telephone for a short time.
When the battery is low, the handset shows Low battery and a ashing
.
Battery indicators Battery Status Action
The screen is blank or
shows Place in charger
and
ashes.
The battery has no or
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows Low
battery and
ashes.
Battery has enough charge
to be used for a short time.
Charge without interruption
(at least 30 minutes).
Full battery icon (
)
appears. The screen
shows HANDSETx (x
represents the handset ID
number 1 to 6).
Battery is charged. To keep the battery
charged, place it in the
charger when not in use.