Quick Start Guide

Specifications are subject to change without notice.
© 2017 VTech Communications, Inc. All rights reserved.
10/17. VM2251_QSG_V1.
Document order number: 96-011936-010-100
Basic operation - Parent unit
Adjust speaker volume
Press + / VOL / - to adjust your parent unit speaker
volume. It determines the volume of sound
transmitted from your baby units.
Zoom
Press to zoom in or out.
Talk to your baby unit
Press and hold TALK and speak to your parent unit.
Your voice is transmitted to the baby unit.
Turn off the screen
Press to enter the main menu when the parent
unit is idle.
Press or to choose , then press to open
the submenu.
Press or to choose the desired time period to
automatically turn off screen
( / - 5 min./ - 30 min. / - 60min.), then
press to confirm your selection and return to
idle screen.
1.
2.
3.
Use the menu
Press MENU to enter the menu, choose a menu item,
or save a setting.
While in the menu:
Press or to scroll among the menu options.
Press or to select an an item.
Press SELECT to confirm your selection.
•
•
•
Turn off the parent unit
Slide to OFF to power off your parent unit.
Basic operation - Baby unit
Night vision
The baby unit has infrared LEDs that allow you to
see your baby at night or in a dark room. When
the baby unit detects low light levels, the infrared
LEDs turn on automatically. The images from this
baby unit is in black and white, andunit is in black and white, and appears
on screen.
NOTES
It is normal if you see a short white glare on your
parent unit screen as the baby unit is adapting to the
dark environment.
When the infrared LEDs are on, the image is in
black and white. This is normal due to external light
sources.
TIP
Depending on the surroundings and other
interfering factors, like lightings, objects, colors and
backgrounds, the display resolution may vary. Adjust
the baby unit’s angle, or place the baby unit at a
higher level to prevent glare and blurry display.
•
•
•
Turn off the baby unit
Slide the ON/OFF switch to OFF to power off your baby unit.
Sound activation
Automatically turns on the parent unit screen when the baby
unit being viewed detects a sound after the screen is turned
off. When no sound is detected within 50 seconds, the
screen is automatically turned off to save power.
Mount the baby monitor (optional)
Align the wall mount bracket and screws
with the holes in the wall as shown.
Slide the wall mount down until it locks
into place.
Use a pencil to mark two holes in
parallel. Make sure they are the
same distance apart as the wall
mount at the bottom of the baby unit.
NOTES
Check for reception strength and
camera angle before drilling the holes.
•
Place the baby unit on the wall mount
bracket. Make sure the baby unit is fixed
on the wall.
Pan or tilt to adjust the baby unit angle.
Drill two holes in the wall (7/32 inch
drill bit). If you dirll the holes into a
stud, insert the screws into the holes.
Tighten the screws until only 1/4 inch
of the screws are exposed.