User Guide

Using the WebUI 48 Back to Contents
VCS754 Administrator and Provisioning Manual
Network Pages
You can set up the VCS754 for your network configuration on the Network pages. Your
service provider may require you to configure your network to be compatible with its
service, and the VCS754 settings must match the network settings.
The network settings are also available as parameters in the configuration file. See
“"network" Module: Network Settings” on page 95.
After entering information on this page, click to save it.
Basic Network Settings
Basic Network Settings
Click the link for each setting to see the matching configuration file parameter in “"network"
Module: Network Settings” on page 95. Default values and ranges are listed there.
If you disable DHCP on this page, you must configure static IP settings for the
VCS754. You must be familiar with TCP/IP principles and protocols to configure
static IP settings.
Setting Description
DHCP DHCP is selected (enabled) by default, which means the
VCS754 will get its IP address, Subnet Mask, Gateway, and
DNS Server(s) from the network.
Static IP When Static IP is selected, you must enter a static IP
address for the VCS754, as well as addresses for the
Subnet Mask, Gateway, and DNS Server(s).
IP Address
If DHCP is disabled, enter a static IP address for the VCS754.
Subnet Mask Enter the subnet mask.
Gateway Enter the address of the default gateway (in this case, your
router).