USB 711 Accessory Handset for USB7100 05:00PM VTECH 8883472005 EDIT 1/19 DELETE
© 2005 VTech Telecommunications Ltd. All rights reserved. VTech brand and logo are registered trademarks of VTech Telecommunications Ltd.
USB 711 Accessory Handset for USB7100 Table of contents Getting Started Appendix Quick reference guide ..................2 In case of difficulty .......................6 Parts checklist ...............................3 Care and maintenance ..................6 Belt clip & optional headset..........3 Important safety instructions........7 Warranty .......................................9 Installation & registration FCC, ACTA & IC regulations .......11 Battery installation & charging......
Getting Started Quick reference guide Handset V ^ Press to scroll up in menus. While entering names or numbers, press to move the cursor to the right. Press to scroll down in menus. While entering names or numbers, press to move the cursor to the left. SOFTKEY SOFTKEY Press a softkey to select an option displayed just above the key. SOFTKEY SOFTKEY Press a softkey to select an option displayed just above the key. CID Press to display Phonebook entries. Press to display Caller ID log.
Getting Started Parts checklist Remember to save your sales receipt and original packaging in case you ever need to ship your telephone for warranty service. Check to make sure the telephone package includes the following: Battery compartment cover Handset charger Belt clip Telephone handset Batteries (2) Belt clip & optional headset Install belt clip as shown below if desired. For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). Plug 2.
Getting Started Battery installation & charging Install batteries as shown below, plug in the charger, then place the handset in the charger for 15 hours before first use. You can keep batteries charged by placing the handset in the charger after each use. When batteries are fully depleted, a full recharge takes 15 hours. Note: The screen will be blank until the batteries are charged enough to activate it.
Getting Started Registering your new handset After the batteries are fully charged, follow the procedure below to register the handset to the base. NOT REGISTERED MENU 1 Select MENU. 2 Highlight “Register,” then select OK. The screen will display, "Search Base." Press MENU to begin 1 > REGISTER 2 DEREGISTER OK SEARCH BASE 3 Press and hold the LOCATE HANDSET button on the base for at least 30 seconds. 4 The handset should beep to indicate the registration has completed.
Appendix In case of difficulty If you have difficulty with your phone, launch the Vtech USB 7100 Phone Suite application on your PC, click the User Manual link, then consult the In Case of Difficulty section. If you cannot resolve the problem, please visit our Web site at www.vtechphones.com, or call 1-888-347-2005. In Canada, call 1-888-211-2005 or visit www.vtechcanadacom. Care and maintenance Your cordless telephone contains sensitive electronic parts, so it must be treated with care.
Appendix Important safety instructions When using your telephone equipment, please observe basic safety precautions to reduce the risk of fire, electric shock and injury, including the following: 1 Read and understand all instructions. 2 Follow all warnings and instructions marked on the product. 3 Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
Appendix Important safety instructions 12 Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions: • When the power supply cord or plug is damaged or frayed. • If liquid has been spilled onto the product. • If the product has been exposed to rain or water. • If the product does not operate normally by following the operating instructions.
Appendix Warranty What does this limited warranty cover? What is not covered by this limited warranty? The manufacturer of this VTech product, VTech Communications, warrants to the holder of a valid proof of purchase (“Consumer” or “you”) that the product and all accessories provided by VTech in the sales package (“Product”) are free from material defects in material and workmanship, pursuant to the following terms and conditions, when installed and used normally and in accordance with operation instruct
Appendix Warranty Other Limitations transit and transportation and are responsible for delivery or handling charges incurred in the transport of Product(s) to the service location. VTech will return repaired or replaced product under this limited warranty to you, transportation, delivery or handling charges prepaid. VTech assumes no risk for damage or loss of the Product in transit.
Appendix FCC, ACTA and IC regulations This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Appendix FCC, ACTA and IC regulations called. In most, but not all areas, the sum of all RENs should be five (5.0) or less. For more information, please contact your local telephone company. the telephone company is required to inform you of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper functioning of this product.
Appendix FCC, ACTA and IC regulations IC (Industry Canada) power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. This telephone is registered for use in Canada. The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.
www. vtechphones .com www. vtechcanada .com Distributed in the U.S.A. by VTech Communications, Inc. Beaverton, Oregon, 97008 1-888-347-2005 Distributed in Canada by VTech Telecommunications Canada Ltd. 200-7671 Alderbridge Way, Richmond, B.C. V6X 1Z9 1-888-211-2005 © 2005 VTech Telecommunications Ltd. All rights reserved. VTech brand and logo are trademarks of VTech Telecommunications Ltd. Printed in China. Issue 1.6 VTech 12/05/05.
