User`s manual

43
There is no dial tone.
First try all the suggestions above.
Make sure you plug the handset cord securely and firmly into the
jack on
the telephone base and the corded handset.
If the previous suggestions do not work, disconnect the telephone line from
the console and connect it to a different telephone. If there is no dial tone on
that telephone either, the problem is in your wiring or local service. Contact
your telephone service provider.
Your telephone line cords or Ethernet cable might be defective. Try installing
new ones.
Make sure a line is selected. Press a line key (L1-L4) or SPEAKER .
If there is no dial tone when you press HEADSET, make sure the corded
headset is firmly connected to the
jack.
I cannot dial out.
First try all the suggestions above.
Make sure you have a dial tone before dialing. The corded handset might
take a second or two to connect the console and produce a dial tone. This is
normal. Wait an extra second before dialing.
Make sure the telephone is set to the correct dial mode (pulse dial or tone
dial) for the service in your area. Refer to Dial mode section in the online
complete user’s manual to set the dial mode.
If the other telephones in your building are having the same problem,
contact your telephone service provider.
•
•
•
•
•
•
•
•
•
•
Appendix
Troubleshooting