User`s manual

Answering system

Answering system settings

Number of rings

You can set the answering system to answer an incoming call after two, three,

four, five or six rings. You can also select toll saver. If toll saver is selected, the

answering system answers a call after two rings when you have new messages,

or after four rings when there are no new messages. By default, the answering

system answers an incoming call after four rings.

To set the number of rings:

Using a cordless handset or the telephone base:

1. When the handset or telephone base is in idle mode, press MENU/SELECT to

enter the main menu.

2. Press qCID or pDIR to scroll to >Answering sys, then press MENU/SELECT.

3. Press qCID or pDIR to scroll to >Ans sys setup, then press MENU/SELECT.

4. Press qCID or pDIR to scroll to >

of rings, then press MENU/SELECT.

5. Press qCID or pDIR to choose among >2, >3, >4, >5, >6 or >Toll saver.

6. Press MENU/SELECT to save the setting.

Remote access code

To access your answering system remotely from any touch-tone phone, you

need to enter a two-digit number (00-99). By default, the remote access code

is 19.

To change the remote access code:

Using a cordless handset or the telephone base:

1. When the handset or telephone base is in idle mode, press MENU/SELECT

to enter the main menu.

2. Press qCID or pDIR to scroll to >Answering sys, then press MENU/SELECT.

3. Press qCID or pDIR to scroll to >Ans sys setup, then press MENU/SELECT.

4. Press qCID or pDIR to scroll to >Remote code, then press MENU/SELECT.

5. Use the dialing keys to enter a 2-digit number. To backspace and delete

a digit, press MUTE/DELETE on the handset or X/DELETE on the

telephone base.

6. Press MENU/SELECT to save the setting.