User`s manual

Telephone operation

Voice command

TL86103 supports voice recognition when the phone system is connected

to AT&T Softphone Call Manager installed on your computer (see page 11).

You can make calls on line 1 or line 2 (according to the line preference set,

see page 48) through the voice command (name dialing) function using the

telephone base or a cordless handset.

Before making a voice command, make sure your desired contacts are

in the phonebook directory of the AT&T Softphone Call Manager that is

independent from the home and downloaded directories. For detailed instructions,

please refer to the Installation and Operation Guide in the CD-ROM which

comes with the package.

To make a call using voice command:

Using a cordless handset or the telephone base:

Press MENU in idle mode.

Press CID or DIR on the cordless handset, or CID, DIR, /RECORD, or

/DELETE on the telephone base to highlight Voice Command, and then

press SELECT . The screen displays Processing Voice command... You hear

“Who would you like to call?”, followed by a confirmation beep.

3. Say your desired contact name, which is stored in the phonebook directory

of the AT&T Softphone Call Manager, to dial.

NOTES:

Make sure the USB cable is connected to the telephone base and your computer (page 11).

Make sure the AT&T Softphone Call Manager is launched on your computer.

When there is an incoming call from any line, the voice recognition will stop immediately.

To say a command again when processing, press STOP and select Voice Command again from

the menu.

To cancel a voice command activity before making a voice command, say “Cancel”.

If the voice command setting is set as

Disable in the AT&T Softphone Call Manager,

voice command requests will be rejected.

•