User`s manual

Getting started

Installation options

Wall mount to tabletop installation

To change the telephone base from the wall mount position to tabletop

position, follow the steps below.

Unplug the power adapter from the power outlet. Unplug the telephone

line cord from the wall jack (or DSL filter). If the telephone line cord and

power adapter cord are bundled, untie them first. Push the telephone base

up to remove it from wall.

Put the corded handset aside. Hold down the switch hook on the

telephone base, and then slide the handset tab upwards to remove it

from the slot. Rotate the handset tab by 180 degrees. Then, replace the

handset tab into the slot until it locks into position.

Gently pull upward to release the wall mount bracket. Rotate the wall

mount bracket up to tabletop position and push it into the telephone base

until it clicks into place.

Plug the telephone line cord (or DSL filter) into the wall jack. Plug the power

adapter into an electrical outlet not controlled by a wall switch. Bundle the

telephone line cord and power adapter cord neatly with twist ties if necessary.