User`s manual

13
Getting started
Battery installation and charging
Install the battery as shown below. Once you have installed the battery, the
screen indicates the battery status (see the table below). For best performance,
keep the cordless handset in charger when not in use. The battery is fully
charged after 11 hours of continuous charging. See the table in the Technical
specifications section on page 156 for battery operating times.
If the screen shows Place in charger and flashes, you need to charge the
cordless handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarized the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
Place in charger and flashes.
The battery has no or very little
charge. The handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and flashes.
Battery has enough charge to be
used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows HANDSET X. Battery is charged. To keep the battery
charged, place it in charger
when not in use.
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment. Insert the
supplied battery with the
label THIS SIDE UP facing
up as indicated.
Step 2
Align the cover flat
against the battery
compartment, and then
slide it upwards until it
clicks into place.
IMPORTANT INFORMATION:
Use only the supplied rechargeable battery or replacement battery (model BT183342/
BT283342). To order, visit our website at www.telephones.att.com or call
1 [phone]. In Canada, dial 1 [phone].
If you do not use the cordless handset for a long time, disconnect and remove the battery to
prevent possible leakage.
•
•
Step 3
Charge the cordless handset by placing it face forward in
the charger. The CHARGE light on the top of the handset
is on during charging.
CHARGE light
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles : BT183342/BT283342 (2.4V 400mAh Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine BY1142
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles : BT183342/BT283342 (2.4V 400mAh Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine BY1142
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles : BT183342/BT283342 (2.4V 400mAh Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine BY1142
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles : BT183342/BT283342 (2.4V 400mAh Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine BY1142
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles : BT183342/BT283342 (2.4V 400mAh Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine BY1142
33