User`s manual

9
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 15 for details.
Telephone base installation
Plug the corded handset cord into the CORDED HS jack at the back of the
telephone base. Route the cord through the slot.
Plug the red end of the telephone base power adapter into the POWER jack
at the bottom of the telephone base. Plug the other end into an electrical
outlet not controlled by a wall switch. Route the cord through the slot.
3. Plug the telephon
e line(s) according to the instructions below.
Option 1: If you have separate wall jacks for each line, plug the telephone
lines as shown below.
1.
2.
Plug one end of the black
telephone line cord into the
LINE 1/L1+L2 telephone jack
at the bottom of the telephone
base.
Route the cords through
the slots.
Line 2 telephone
wall jack
Line 1 telephone
wall jack
Plug the other ends of
the telephone line cords
into the telephone wall
jack, or into DSL filters if
you have DSL high-speed
Internet service.
Plug one end of the clear
telephone line cord into the
LINE 2 telephone jack at the
bottom of the telephone base.
Raise the antenna.
Route the cords through
the slots.