User`s manual

3
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below).
For best performance, keep the handset in the telephone base or charger
when not in use.
The battery is fully charged after 10 hours of continuous charging.
If you place the handset in the telephone base or the charger without
plugging in the battery, the screen displays No Battery.
•
•
•
Battery indicators Battery status
Action
The screen is blank, or
displays Put in charger
and flashes.
The battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Add and register a handset
This telephone system accommodates up to five handsets. Each new handset must
be registered with the telephone base before use. Additional handsets registered to
the telephone base are assigned numbers in the sequential order.
When first purchased and properly charged, each expansion handset shows
To register HS... and ...see manual alternately. Charge the handset before
registering it to the telephone base.
To register a handset:
Place the new/non-registered handset in the telephone base.
2. After about 10 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you hear
a beep. The registration process takes about 90 seconds to complete.
1.
Do not place the
handset in the charger.
When the battery is fully charged, you can expect the following performance:
Operation Operating time
While in use (talking*) Up to 7 hours
While in speakerphone mode (talking*) Up to 3.5 hours
While not in use (standby**) Up to 5 days
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.