User`s manual

60
Your telephone can support up to five cordless handsets (AT&T model TL30100,
sold separately). The handset needs to register with the telephone base before
use. You must register each handset separately.
The handsets provided within your product box are
already registered as HANDSET 1 and so forth. Additional
handsets are assigned numbers in the order they are
registered (HANDSET 2 to HANDSET 5).
When first purchased, all expansion handsets alternately
display 1.Press HS LOC on base 4 sec and 2.Then press
# on handset. The new handset should be charged
without interruption for at least 30 minutes before
registering to the telephone base.
To register a handset to your telephone base:
Make sure the handset is out of the telephone base
or charger and alternately shows 1.Press HS LOC
on base 4 sec and 2.Then press # on handset
before you begin the registration.
Press and hold HANDSET LOCATOR on the
telephone base for about four seconds (until the
IN USE light on the telephone base is on) and then
release the button.
Press # (pound key) on the handset. The screen shows
Registering...Please wait. It takes up to one minute to
complete the registration. HANDSET registered and
then HANDSET X appears on the screen, with X being
the handset number (1-5) and the handset beeps. The
handset is now registered with the telephone base.
If the registration is not successful, the handset screen
shows Registration failed. Please start again from
step 1 above.
NOTE: You cannot register a handset if any other system handset is
in use.
1.
2.
3.
Appendix
Adding and registering a handset
HANDSET 2
10/20
10:30
PM
1.Press HS LOC
on base 4 sec
--/--
--:--
2.Then press #
on handset
--/--
--:--
HANDSET
registered
Registering...
Please wait